|
It is important to measure correctly to ensure that you purchase the correct size springs
If you need assistance please Call Toll Free 714-552-9477
or email garagedoorparts@gmail.com
Torsion Springs - Choose Inside Diameter Below
(Inside Diameter is taken at the break or Indicated on Stationary Cone)
(Only measure your broken or unwound torsion springs)
1. Determine Length of spring(s) from coil to coil only. (Don't measure silver end cones)
2. Determine Coil Diameter: Count all coils or winds from end to end within the length in step 1.
3. Determine Inside Diameter: You have two silver cones on your spring(s) The cone that is mounted near the center has
numbers etched or embossed on the outer edge. ie. 175 or 200, 225 etc Indicates Inside Diameter or I.D.
TORSION SPRING SHOWN BELOW
Note: Left Hand Wound Torsion Spring Shown in Diagram
Proper Orientation: Standing in the Garage looking out to the driveway
Right side of center is Left Wind
Left side of center is Right Wind
Please note: set screws are always red, and cones may not be colored at all
If you need assistance determining winding, please call 714-552-9477
(Please be certain both springs are the same in measurement.)
Take a and Email it to us if you're unsure
Visit : http://www.repairmygarage.com
|
